From 235cba85286455901e591dc010a3e6c17d57b21c Mon Sep 17 00:00:00 2001 From: Ludovic Courtès Date: Fri, 6 Nov 2015 23:42:24 +0100 Subject: doc: Make the ifconfig command more visible. Suggested by Adam Pribyl . * doc/guix.texi (System Installation): Move the 'ifconfig' command to an @example. --- doc/guix.texi | 11 ++++++++--- 1 file changed, 8 insertions(+), 3 deletions(-) (limited to 'doc/guix.texi') diff --git a/doc/guix.texi b/doc/guix.texi index 7e5f9c774b..fd80a30f51 100644 --- a/doc/guix.texi +++ b/doc/guix.texi @@ -5293,14 +5293,19 @@ To install the system, you would: @enumerate @item -Configure the network, by running @command{ifconfig eno1 up && dhclient -eno1} (to get an automatically assigned IP address from the wired +Configure the network, by running: + +@example +ifconfig eno1 up && dhclient eno1 +@end example + +to get an automatically assigned IP address from the wired network interface controller@footnote{ @c http://cgit.freedesktop.org/systemd/systemd/tree/src/udev/udev-builtin-net_id.c#n20 The name @code{eno1} is for the first on-board Ethernet controller. The interface name for an Ethernet controller that is in the first slot of the first PCI bus, for instance, would be @code{enp1s0}. Use -@command{ifconfig -a} to list all the available network interfaces.}), +@command{ifconfig -a} to list all the available network interfaces.}, or using the @command{ifconfig} command. The system automatically loads drivers for your network interface -- cgit 1.4.1