1 files changed, 61 insertions, 0 deletions
diff --git a/utils/afl_network_proxy/README.md b/utils/afl_network_proxy/README.md
new file mode 100644
index 00000000..a5ac3578
--- /dev/null
+++ b/utils/afl_network_proxy/README.md
@@ -0,0 +1,61 @@
+# afl-network-proxy
+
+If you want to run afl-fuzz over the network than this is what you need :)
+Note that the impact on fuzzing speed will be huge, expect a loss of 90%.
+
+## When to use this
+
+1. when you have to fuzz a target that has to run on a system that cannot
+   contain the fuzzing output (e.g. /tmp too small and file system is read-only)
+2. when the target instantly reboots on crashes
+3. ... any other reason you would need this
+
+## how to get it running
+
+### Compiling
+
+Just type `make` and let the autodetection do everything for you.
+
+Note that you will get a 40-50% performance increase if you have libdeflate-dev
+installed. The GNUmakefile will autodetect it if present.
+
+If your target has large test cases (10+kb) that are ascii only or large chunks
+of zero blocks then set `CFLAGS=-DCOMPRESS_TESTCASES=1` to compress them.
+For most targets this hurts performance though so it is disabled by default.
+
+### on the target
+
+Run `afl-network-server` with your target with the -m and -t values you need.
+Important is the -i parameter which is the TCP port to listen on.
+e.g.:
+```
+afl-network-server -i 1111 -m 25M -t 1000 -- /bin/target -f @@
+```
+
+### on the (afl-fuzz) master
+
+Just run afl-fuzz with your normal options, however the target should be
+`afl-network-client` with the IP and PORT of the `afl-network-server` and
+increase the -t value:
+```
+afl-fuzz -i in -o out -t 2000+ -- afl-network-client TARGET-IP 1111
+```
+Note the '+' on the -t parameter value. The afl-network-server will take
+care of proper timeouts hence afl-fuzz should not. The '+' increases the
+timeout and the value itself should be 500-1000 higher than the one on 
+afl-network-server.
+
+### networking
+
+The TARGET can be an IPv4 or IPv6 address, or a host name that resolves to
+either. Note that also the outgoing interface can be specified with a '%' for
+`afl-network-client`, e.g. `fe80::1234%eth0`.
+
+Also make sure your default TCP window size is larger than your MAP_SIZE
+(130kb is a good value).
+On Linux that is the middle value of `/proc/sys/net/ipv4/tcp_rmem` 
+
+## how to compile and install
+
+`make && sudo make install`
+