diff options
Diffstat (limited to 'utils/afl_network_proxy')
| -rw-r--r-- | utils/afl_network_proxy/README.md | 21 |
1 files changed, 12 insertions, 9 deletions
diff --git a/utils/afl_network_proxy/README.md b/utils/afl_network_proxy/README.md index 05659c45..c34463e2 100644 --- a/utils/afl_network_proxy/README.md +++ b/utils/afl_network_proxy/README.md @@ -1,12 +1,13 @@ # afl-network-proxy -If you want to run afl-fuzz over the network than this is what you need :) +If you want to run afl-fuzz over the network, then this is what you need. :) Note that the impact on fuzzing speed will be huge, expect a loss of 90%. ## When to use this 1. when you have to fuzz a target that has to run on a system that cannot - contain the fuzzing output (e.g. /tmp too small and file system is read-only) + contain the fuzzing output (e.g., /tmp too small and file system is + read-only) 2. when the target instantly reboots on crashes 3. ... any other reason you would need this @@ -28,32 +29,34 @@ For most targets this hurts performance though so it is disabled by default. Run `afl-network-server` with your target with the -m and -t values you need. Important is the -i parameter which is the TCP port to listen on. e.g.: + ``` afl-network-server -i 1111 -m 25M -t 1000 -- /bin/target -f @@ ``` ### on the (afl-fuzz) main node -Just run afl-fuzz with your normal options, however the target should be +Just run afl-fuzz with your normal options, however, the target should be `afl-network-client` with the IP and PORT of the `afl-network-server` and increase the -t value: + ``` afl-fuzz -i in -o out -t 2000+ -- afl-network-client TARGET-IP 1111 ``` -Note the '+' on the -t parameter value. The afl-network-server will take -care of proper timeouts hence afl-fuzz should not. The '+' increases the -timeout and the value itself should be 500-1000 higher than the one on -afl-network-server. + +Note the '+' on the -t parameter value. The afl-network-server will take care of +proper timeouts hence afl-fuzz should not. The '+' increases the timeout and the +value itself should be 500-1000 higher than the one on afl-network-server. ### networking The TARGET can be an IPv4 or IPv6 address, or a host name that resolves to either. Note that also the outgoing interface can be specified with a '%' for -`afl-network-client`, e.g. `fe80::1234%eth0`. +`afl-network-client`, e.g., `fe80::1234%eth0`. Also make sure your default TCP window size is larger than your MAP_SIZE (130kb is a good value). -On Linux that is the middle value of `/proc/sys/net/ipv4/tcp_rmem` +On Linux that is the middle value of `/proc/sys/net/ipv4/tcp_rmem` ## how to compile and install |